** Diffuser comes with a complimentary 5ml Essential Oil.
Hand blown glass diffuser
Colour change / auto turn off function
Run time approx 3 hours
Mist Diffuser Instructions & INFO.
Regular sized diffusers hold approx 140ml of water Up to 8 hours of run time from full
1. Remove outer casing
2. Remove the cap (it has the long tube pointing up)
3. Fill to the line with cold water
4. Add a few drops of fragrance, a max of 5 drops. More than this may result in a blocked unit.
5. Connect to power and it will beep.
6. Press the button on the right to start the mist cycle
7. Red light is intermittent mist and green is constant mist
8. Press the button on the left to alter the light functions. Press once for rotating light, press multiple times to choose a static colour lights will turn off at the end of the colours.
9. The tank will get warm during operation but not hot.
10.The water and oil may become milky in appearance, this is normal.
11.If there is any browning, scoring or damage to the vibration plate the warranty is voided.
12.Unit will automatically turn off when empty
Rinse all fragrance out of the unit at the end of each cycle
Only fill to the line (this will rub off if you get fragrance on it).
Do not get water in the air outlet on the side (that odd-looking hole)
Use only a few drops of fragrance, too much oil is bad!
Lights and button functions:
Button on the left is for the lights.
Button on the right is on/off & mist program.
Green is constant
Red is intermittent. It will give bursts of mists rather than a continuous stream. Unit runs longer on this cycle.
If the unit beeps & turns off after being switched on, it’s blocked.
Do not attempt to use until you have thoroughly cleaned the unit.
Run a water only cycle and retry.
Once a week add a teaspoon of vinegar to a water cycle. Allow to run for 5 minutes, empty and rinse.
If the unit won’t turn on you may have burnt out your motor due to lack of care.
When not in use empty and store the tank upside down to prevent mould.
Please take care not to touch, push or poke the vibration plate in the bottom as this will damage your unit.
Inside the top cap there is a small plate that covers the air hole. Sometimes bubbles will get caught in here and prevent the mist escaping. Simply remove the cap shake excess water and replace. As soon as the cap is removed you’ll see the water vapour/bubbling.
The unit is still working, it just has an air lock in the cap. It’s also possible during cleaning this is pushed on too far and blocks the air hole.
If your unit is not producing mist, noisy, is beeping and cutting out you will need to clean it.
Essential oil diffuser placement tips
Although you can use them on a floor, placing them at least 2 feet above the floor is ideal, similar to humidifiers
Bedroom: Placing your diffuser a few feet from your bed is recommended. A minimum of 3 feet or so is good
Don’t put your diffuser where it will be constantly exposed to sunlight (near a window), Sunlight and warmth create a great breeding ground for the build up & growth of nasties such as algae and bacteria.
Avoid placing it on top of or very close to wooden surfaces subject to moisture or water damage. A tray or other water-resistant cover underneath it can prevent problems from mist droplets or spilled water
A non-metallic, level surface is ideal. Do not place on carpet or similar surfaces that can become damp
For best results, place your diffuser closer to the center of the room or even to one side, where ever convenient (this is a “nice to have” recommendation and not essential)